Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland dwx 52dci lines on zirconia crown surface???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bigj1972" data-source="post: 340191" data-attributes="member: 811"><p>This was inevitable. Remember when you bought the new car, It was so quiet, barely knew it was idling. Couple years later, you might hear a squeak, a rattle, a heat shield pop.</p><p></p><p>These mills are still machines and as they are pushed, slight tolerances will open and you will see anomalies.</p><p>And like a car, you'll have to judge the balance of throwing parts at it vs putting up with the squeak.</p></blockquote><p></p>
[QUOTE="bigj1972, post: 340191, member: 811"] This was inevitable. Remember when you bought the new car, It was so quiet, barely knew it was idling. Couple years later, you might hear a squeak, a rattle, a heat shield pop. These mills are still machines and as they are pushed, slight tolerances will open and you will see anomalies. And like a car, you'll have to judge the balance of throwing parts at it vs putting up with the squeak. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland dwx 52dci lines on zirconia crown surface???
Top
Bottom