Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
PrograMill PM3 - PM5 users here?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Patrick Coon" data-source="post: 327405" data-attributes="member: 11366"><p>Requirements for all the current Programills is 6.5-7bar (97-105psi) and 205 l/min (7.5cfm). Not sure if your information is so you can run your whole lab from the same compressor, but if you have the room, I would recommend a separate compressor to run your mill. This avoids the pressure dropping when you have to run the blaster or dry a cast with the air hose, or shoot flaming cotton tip applicators across the room.</p></blockquote><p></p>
[QUOTE="Patrick Coon, post: 327405, member: 11366"] Requirements for all the current Programills is 6.5-7bar (97-105psi) and 205 l/min (7.5cfm). Not sure if your information is so you can run your whole lab from the same compressor, but if you have the room, I would recommend a separate compressor to run your mill. This avoids the pressure dropping when you have to run the blaster or dry a cast with the air hose, or shoot flaming cotton tip applicators across the room. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
PrograMill PM3 - PM5 users here?
Top
Bottom