Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Denturist
Pour and mount for implant overdentures?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TheLabGuy" data-source="post: 353381" data-attributes="member: 126"><p>Sure,</p><p>-scan the entire overdenture, including intaglio surface. I set up case in exocad, invert intaglio, import bite and opposing scans. </p><p>-Then send over to 3shape ivotion software. For the ones that don't know, 3shape has a denture software, but ivoclars ivotion is a separate software that integrates with 3shape. Uses phonares moulds and allows the case to be setup using the monolithic ivotion pucks (where the pink and teeth are all in same puck...no gluing teeth into pink).</p><p>-then duplicate it (learning the software and moving stuff around takes a little bit, but ivoclar has been pretty good with any technical questions),then mill it. Now you have a duplicate that is stronger than the original...have Doc pick up locator housings chairside. Very quick process once you learn all the tedious tricks that 3shape likes to throw at you. Although, I hear exocad is supposed to integrate with ivotion soon...then the process would be faster...at least for me.</p></blockquote><p></p>
[QUOTE="TheLabGuy, post: 353381, member: 126"] Sure, -scan the entire overdenture, including intaglio surface. I set up case in exocad, invert intaglio, import bite and opposing scans. -Then send over to 3shape ivotion software. For the ones that don't know, 3shape has a denture software, but ivoclars ivotion is a separate software that integrates with 3shape. Uses phonares moulds and allows the case to be setup using the monolithic ivotion pucks (where the pink and teeth are all in same puck...no gluing teeth into pink). -then duplicate it (learning the software and moving stuff around takes a little bit, but ivoclar has been pretty good with any technical questions),then mill it. Now you have a duplicate that is stronger than the original...have Doc pick up locator housings chairside. Very quick process once you learn all the tedious tricks that 3shape likes to throw at you. Although, I hear exocad is supposed to integrate with ivotion soon...then the process would be faster...at least for me. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Community discussion
Denturist
Pour and mount for implant overdentures?
Top
Bottom