Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Lost a finished case when adjusting Crown bottoms......exo.....
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="LarryRDC" data-source="post: 304342" data-attributes="member: 11609"><p>What I usually do in a situation like that is “delete construction”, turn off all the other mesh ( leaving just the designed bridge top) . Save that as an stl. ( name it pre-op). Then re-start the design, loading the scan data only. In expert mode, add new mesh, bring in the saved stl as a pre-op scan( the coordinates will be already aligned),set the new cement gaps, quickly set your teeth proposals with-in the pre-op , a quick run through the wizard, adapt to the pre-op , clean it up and done. Usually only takes about 5 minutes. There may be a better way but this works for me</p></blockquote><p></p>
[QUOTE="LarryRDC, post: 304342, member: 11609"] What I usually do in a situation like that is “delete construction”, turn off all the other mesh ( leaving just the designed bridge top) . Save that as an stl. ( name it pre-op). Then re-start the design, loading the scan data only. In expert mode, add new mesh, bring in the saved stl as a pre-op scan( the coordinates will be already aligned),set the new cement gaps, quickly set your teeth proposals with-in the pre-op , a quick run through the wizard, adapt to the pre-op , clean it up and done. Usually only takes about 5 minutes. There may be a better way but this works for me [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Lost a finished case when adjusting Crown bottoms......exo.....
Top
Bottom