Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Metal
keep Margin shy-ing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="wwcanoer" data-source="post: 109908" data-attributes="member: 706"><p>check the temperature of your burnout oven, and not with those little tabs that melt at set temp., your heating coils could be wearing out so that true temp isn't what the read-out says, or one side is hotter ,etc. when my coils started to fail, my castings were all over the place. the continuity tested ok, but had it re-wound anyway and things are fitting again.</p><p></p><p>good luck!</p></blockquote><p></p>
[QUOTE="wwcanoer, post: 109908, member: 706"] check the temperature of your burnout oven, and not with those little tabs that melt at set temp., your heating coils could be wearing out so that true temp isn't what the read-out says, or one side is hotter ,etc. when my coils started to fail, my castings were all over the place. the continuity tested ok, but had it re-wound anyway and things are fitting again. good luck! [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Metal
keep Margin shy-ing
Top
Bottom