Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Issue with sharing stls from ZirkonZahn to Hyperdent
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MTDentalTech" data-source="post: 295868" data-attributes="member: 20807"><p>Hey, has anyone had an issue with sharing any zz stl files to a third party software. I have been having an issue where on my full arch bridges of zir/PMMA they have at least one implant location where the angle is wrong on the bridge. I have had zz support thoroughly look through the software and scanner and i have had my hyperdent looked at to make sure there is no issue. And it happens no matter if i scan in the ti base vs if i scan in the scan marker. I re scanned in a milled bridge and the screw whole is clearly a different angle on one of the cases from what i designed. The case, other than the angle, milled clean and the bite checks out it is just that the angle is wrong. Its happening on 9/10 cases. Any suggestions would be appreciated.</p></blockquote><p></p>
[QUOTE="MTDentalTech, post: 295868, member: 20807"] Hey, has anyone had an issue with sharing any zz stl files to a third party software. I have been having an issue where on my full arch bridges of zir/PMMA they have at least one implant location where the angle is wrong on the bridge. I have had zz support thoroughly look through the software and scanner and i have had my hyperdent looked at to make sure there is no issue. And it happens no matter if i scan in the ti base vs if i scan in the scan marker. I re scanned in a milled bridge and the screw whole is clearly a different angle on one of the cases from what i designed. The case, other than the angle, milled clean and the bite checks out it is just that the angle is wrong. Its happening on 9/10 cases. Any suggestions would be appreciated. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Issue with sharing stls from ZirkonZahn to Hyperdent
Top
Bottom