Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Removable
Internal Frameworks
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="k2 Ceramic Studio" data-source="post: 91096" data-attributes="member: 1067"><p>Hi pal. We try to keep away from fixture level stuff as our cam is just not set up for it yet but we can scan and mill to any abutment that has a ledge and then mill it in Zr Ti or Cr/Co again I know it sounds a bit soft but we tend to stear clear of the Cr/ Co material as it will kill the mill over time</p><p> so we just stick to Zr and Ti and even pmma over implants. Even did the worlds first oOsteocare milled bar a few months ago, Osteo are good friends of ours and milled off the hex to make it non engaging. All the best Pete</p></blockquote><p></p>
[QUOTE="k2 Ceramic Studio, post: 91096, member: 1067"] Hi pal. We try to keep away from fixture level stuff as our cam is just not set up for it yet but we can scan and mill to any abutment that has a ledge and then mill it in Zr Ti or Cr/Co again I know it sounds a bit soft but we tend to stear clear of the Cr/ Co material as it will kill the mill over time so we just stick to Zr and Ti and even pmma over implants. Even did the worlds first oOsteocare milled bar a few months ago, Osteo are good friends of ours and milled off the hex to make it non engaging. All the best Pete [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Community discussion
Removable
Internal Frameworks
Top
Bottom