Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
"Incorrect outline" error in Splint Studio
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Marcin K" data-source="post: 318206" data-attributes="member: 18437"><p>Reposted here since this may be the better spot for this </p><p></p><p>Has anyone ran into this issue and has anyone diagnosed what causes this error to pop up during the outline stage in splint studio. This error is a nightmare. This is a digital impression. I went ahead and cleaned up as much issues with the scans in meshmixer and made sure there were no additional holes and or tunnels. I even tried to re-mesh the stl scan just in case there was something amiss. Still getting this stupid error.</p><p></p><p>I know i can get around this issue if i Design it in the older software but I'm a fixed technician and I'm hoping to find a solution to this so that the removable department can continue using the same software.</p></blockquote><p></p>
[QUOTE="Marcin K, post: 318206, member: 18437"] Reposted here since this may be the better spot for this Has anyone ran into this issue and has anyone diagnosed what causes this error to pop up during the outline stage in splint studio. This error is a nightmare. This is a digital impression. I went ahead and cleaned up as much issues with the scans in meshmixer and made sure there were no additional holes and or tunnels. I even tried to re-mesh the stl scan just in case there was something amiss. Still getting this stupid error. I know i can get around this issue if i Design it in the older software but I'm a fixed technician and I'm hoping to find a solution to this so that the removable department can continue using the same software. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
"Incorrect outline" error in Splint Studio
Top
Bottom