Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Formlabs Castable Material
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Joshue" data-source="post: 287561" data-attributes="member: 19112"><p>I know no shortcuts, also my burn out processor takes around 2.5 -3 hours I increase the temperature to 720for 1 hour the I hold it 15min, then I heat up to 880 it takes 30 to 40min and then I hold it for 30 to 40 min, I been pressing like this without any problem with milling wax, dipping and modeling wax, but when I try to burn out the formlab casting resin the casting rings brakes(explode) there is any protocol to burnout this product??</p></blockquote><p></p>
[QUOTE="Joshue, post: 287561, member: 19112"] I know no shortcuts, also my burn out processor takes around 2.5 -3 hours I increase the temperature to 720for 1 hour the I hold it 15min, then I heat up to 880 it takes 30 to 40min and then I hold it for 30 to 40 min, I been pressing like this without any problem with milling wax, dipping and modeling wax, but when I try to burn out the formlab casting resin the casting rings brakes(explode) there is any protocol to burnout this product?? [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Formlabs Castable Material
Top
Bottom