Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Entry level desk top mill
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TheLabGuy" data-source="post: 286234" data-attributes="member: 126"><p>Aren't the 4-Axis mills beholden to a special holder and disks that only Jensen can supply? I was in a lab not too long ago and seen there Jensen set-up but I'm not sure it was a Jensen mill is why I ask. However, I'd hesitate on anything that couldn't fit a 98mm puck, so many other options out there when you can mill from any manufacturer in my opinion.</p></blockquote><p></p>
[QUOTE="TheLabGuy, post: 286234, member: 126"] Aren't the 4-Axis mills beholden to a special holder and disks that only Jensen can supply? I was in a lab not too long ago and seen there Jensen set-up but I'm not sure it was a Jensen mill is why I ask. However, I'd hesitate on anything that couldn't fit a 98mm puck, so many other options out there when you can mill from any manufacturer in my opinion. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Entry level desk top mill
Top
Bottom