Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
DP3000 error
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DMC" data-source="post: 102164" data-attributes="member: 430"><p>Open HMS....what is your pick-up location? You can Home the X, then command the X-axis into that position and see the reading of actual position (or at least what the printer <em>thinks</em> is the position based on encoder counts). Did it make it? Try it over and over to 2x check.</p><p></p><p>(I bet you need the X-axis encoder cleaned)</p><p></p><p>I run my printers with the front door off to keep air flow going and I have never had to clean my strip on current printer for Four years now.</p></blockquote><p></p>
[QUOTE="DMC, post: 102164, member: 430"] Open HMS....what is your pick-up location? You can Home the X, then command the X-axis into that position and see the reading of actual position (or at least what the printer [I]thinks[/I] is the position based on encoder counts). Did it make it? Try it over and over to 2x check. (I bet you need the X-axis encoder cleaned) I run my printers with the front door off to keep air flow going and I have never had to clean my strip on current printer for Four years now. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
DP3000 error
Top
Bottom