updated photos of difficult emax case

[grabo]

This was Difficult case i posted previously in the forum for advice on how different techs would build this job ,central was very protrusive labially, i have been waiting for the final photo from the dentist before i posted this ,but alas i am still waiting so here goes!Apparently it looked good so ill post final pic if i do indeed receive it

 

[Markyboy]

Looks like you did a nice job. What ingot did you end up using? LT?
What did you layer the incisal with?

 

[grabo]

Hi marky ,i did two separate ingots ,both LT A1 ,just waxed up in differnt ways as u can see in the pic .I ended up using the cut back with the mamelon effect .i Build dentine and made a back wall of pure OE1 with OE3 on ridges and baked ,then stained mamelon effect onto the OE1 to recreate mamelons as in patient photo.Then completed thin covering of NT over entire surface .I feel the maybe should have used a HT ingot as the tooth is very protrusive and the LT ingot shines slightly though in middle third of tooth ,making it slightly high in value