Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland DWX51D/Sum3D Anyone ever have this happen?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="zero_zero" data-source="post: 229763" data-attributes="member: 9932"><p>It should do a collision check or alert if you placed something too close the the edge...it happened to me long time ago, it cut a nice groove into the disk clamp before the controller realized there's an overload on the spindle and stopped the mill. Don't know what could've caused it...nowadays we run a quick simulation to make sure everything checks out before we start to cut. It saved me quite a few burs over the years...</p></blockquote><p></p>
[QUOTE="zero_zero, post: 229763, member: 9932"] It should do a collision check or alert if you placed something too close the the edge...it happened to me long time ago, it cut a nice groove into the disk clamp before the controller realized there's an overload on the spindle and stopped the mill. Don't know what could've caused it...nowadays we run a quick simulation to make sure everything checks out before we start to cut. It saved me quite a few burs over the years... [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland DWX51D/Sum3D Anyone ever have this happen?
Top
Bottom