Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
New inLab MC 5-Axis "Open" Mill
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cadfan" data-source="post: 191183" data-attributes="member: 10618"><p>additional to Zero Zero true 5 ax is like driving thrue pylons left right , left right this works at low angels with higher speed as higher the angles over 10- 15 degrees as lower the speed . Hard angles which are especially on the outside surface are often better milled with 3 plus 2 if the strategie allows positioning as often as needed. Inside crowns true 5 ax is better because tools go down angled 3-15 degrees not causing a shaft collision or the shaft is a bit smaller but problems with smaller tools instability. B axii are most time the limitation factor.</p></blockquote><p></p>
[QUOTE="cadfan, post: 191183, member: 10618"] additional to Zero Zero true 5 ax is like driving thrue pylons left right , left right this works at low angels with higher speed as higher the angles over 10- 15 degrees as lower the speed . Hard angles which are especially on the outside surface are often better milled with 3 plus 2 if the strategie allows positioning as often as needed. Inside crowns true 5 ax is better because tools go down angled 3-15 degrees not causing a shaft collision or the shaft is a bit smaller but problems with smaller tools instability. B axii are most time the limitation factor. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
New inLab MC 5-Axis "Open" Mill
Top
Bottom