Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Milling Burs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cadfan" data-source="post: 167093" data-attributes="member: 10618"><p>yes you can you have a micro switch in your ag but vhf useses on the 4 ax conductive by way of a small part in the spindel if this fail you have trooble spindel change but saves 100 dollar production cost for vhf. diamond in not conductive . Its only a timecounter 5 or ten hours reset and look after what time you get chipping most fz brands chip a bit sooner than the other with more aluoxide</p></blockquote><p></p>
[QUOTE="cadfan, post: 167093, member: 10618"] yes you can you have a micro switch in your ag but vhf useses on the 4 ax conductive by way of a small part in the spindel if this fail you have trooble spindel change but saves 100 dollar production cost for vhf. diamond in not conductive . Its only a timecounter 5 or ten hours reset and look after what time you get chipping most fz brands chip a bit sooner than the other with more aluoxide [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Milling Burs
Top
Bottom