Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Milling Bur Life
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike2" data-source="post: 262600" data-attributes="member: 943"><p>No, what mills, I'm guessing the M200 (3-4axis). I would suspect that your calibration is off or your milling very hard green state Zr. I could on average get 60-80 units on my 2mm tool(roughing tool #6) and more on my 1mm,#2 and my 2mm fine cut,#1, about 200... using Preciso CAM. It is critical that the touchpoint have no visible divots. If you want to speak about it pm me. You will receive plenty of feedback here on this topic, but I only use the tools made by VHF and my tool cost is third cheapest part of makingFCZ crowns. PM if you'd like more info.</p></blockquote><p></p>
[QUOTE="Mike2, post: 262600, member: 943"] No, what mills, I'm guessing the M200 (3-4axis). I would suspect that your calibration is off or your milling very hard green state Zr. I could on average get 60-80 units on my 2mm tool(roughing tool #6) and more on my 1mm,#2 and my 2mm fine cut,#1, about 200... using Preciso CAM. It is critical that the touchpoint have no visible divots. If you want to speak about it pm me. You will receive plenty of feedback here on this topic, but I only use the tools made by VHF and my tool cost is third cheapest part of makingFCZ crowns. PM if you'd like more info. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Milling Bur Life
Top
Bottom