J
Josh Claxton
Member
Full Member
- Messages
- 25
- Reaction score
- 0
Heya Riley! A little late on this, but with Galway + you can also right click teeth that will be preps and convert them to pontics from Expert mode. I've seriously considered telling people to design everything as waxup teeth/pontics instead of using full anatomic just because things rarely line up great.
Once you've converted them you will see the teeth setup will always be pontics, then you can tell it to convert to waxup and they will to sync whatever is closest to the prep to margin.
- josh
P.S. If you're using Sirona's connect case center (I unaffectionately call it C3) You can make it auto-download cases into a folder, which you can then set your Exocad DB to have a watcher on from the DB settings and import cases directly into Exocad. They won't have your naming convention, but if you tell it to export for Exocad / dentalproject files you will also get the Dr.'s questionably marked margins.
It's one of the worst scanners though, just ahead of Shining 3D's monstrosity of a web portal / lack of scan stitching.
Once you've converted them you will see the teeth setup will always be pontics, then you can tell it to convert to waxup and they will to sync whatever is closest to the prep to margin.
- josh
P.S. If you're using Sirona's connect case center (I unaffectionately call it C3) You can make it auto-download cases into a folder, which you can then set your Exocad DB to have a watcher on from the DB settings and import cases directly into Exocad. They won't have your naming convention, but if you tell it to export for Exocad / dentalproject files you will also get the Dr.'s questionably marked margins.
It's one of the worst scanners though, just ahead of Shining 3D's monstrosity of a web portal / lack of scan stitching.