Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
DWX50 skipping the fine milling stage
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Fred J" data-source="post: 108862" data-attributes="member: 10239"><p>I'm new to the forum and had the same problem with my DWX50 running with Delcam SW. Every once in a while we get a crown that doesn't seem to "mill all the way". It seems to either mill too much material or not enough. It can either be inside or on the outside surface. I will re load the job again and it mills fine. I am not doing anything different between the two job runs. Both load and simulate fine. </p><p>Our reseller took a look at the simulated tool paths within Delcam and said that everything looked fine, he seemed to think it was a communication error between the SW and Machine. I still don't have a definite answer from him, just "let me make a few calls".</p></blockquote><p></p>
[QUOTE="Fred J, post: 108862, member: 10239"] I'm new to the forum and had the same problem with my DWX50 running with Delcam SW. Every once in a while we get a crown that doesn't seem to "mill all the way". It seems to either mill too much material or not enough. It can either be inside or on the outside surface. I will re load the job again and it mills fine. I am not doing anything different between the two job runs. Both load and simulate fine. Our reseller took a look at the simulated tool paths within Delcam and said that everything looked fine, he seemed to think it was a communication error between the SW and Machine. I still don't have a definite answer from him, just "let me make a few calls". [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
DWX50 skipping the fine milling stage
Top
Bottom