cumino
Active Member
Full Member
- Messages
- 110
- Reaction score
- 8
9 unit bridge with 4 abutments, ( Biomet 3i ext hex, 4.1mm ) need to angle two of them as screw holes are buccal
Framework design for porcelain, are grouped at present.
Have checked in the control panel, can angle up to 15 degrees, thats enough, but cannot figure out how/where in the design to do it in Dental Design
Thanks in advance
Framework design for porcelain, are grouped at present.
Have checked in the control panel, can angle up to 15 degrees, thats enough, but cannot figure out how/where in the design to do it in Dental Design
Thanks in advance