B
BLUE
Member
Full Member
- Messages
- 92
- Reaction score
- 1
Hello,
Just tried out the acetal partial with 3shape- designed and milled it. No sintered.
Fit was good on the model. But it seems to be really thin. The major connector was 1mm and the grid or
Mesh area was 0.5 mm.
What is the minimum or recommended thickness on this material?
I am not sure it can be that thin. And when I tried to bend it, I can almost touch the edges of each side. Way
Too flexible.
Is this normal? Is this material supposed to flex like that?
Thank you
Just tried out the acetal partial with 3shape- designed and milled it. No sintered.
Fit was good on the model. But it seems to be really thin. The major connector was 1mm and the grid or
Mesh area was 0.5 mm.
What is the minimum or recommended thickness on this material?
I am not sure it can be that thin. And when I tried to bend it, I can almost touch the edges of each side. Way
Too flexible.
Is this normal? Is this material supposed to flex like that?
Thank you