Woohoo 450i

eyeloveteeth

eyeloveteeth

Well-Known Member
Full Member
Messages
2,169
Reaction score
275
I don't believe you would mill CA's from a disc in the 450i. The I'm 550, not sure. I have both and prefer to mill from a blank. The cost of he blank is obviously more than the material cost from a disc. However, tool cost, added machine time and probable increase in remakes will eat into the savings. Not to mention frustration. Milling from blanks is widely accepted. Biomet 3i does it and I'm sure there are more very well known players doing the same.
Disc milling requires 8 or more different tools and Significantly more complex mill Stratergies.
Good luck with the 750. You will love it for sure.

if i'm not mistaken

Biohorizons
Straumann
Biomet
Neoss

all mill from a blank vs Ti puck or Rod
 
KentPWalton

KentPWalton

Well-Known Member
Full Member
Messages
1,789
Reaction score
265
It's ok..."Assumption is the mother of all Foulups!"

Travis Dane(Eric Bogosian) in Under Siege 2
 
Top Bottom