Where are you spraying and cleaning zirconia?

[tehnik]

Hi!

Simple question. Where are you spraying your abutments etc... As the spray material gets into computers and other equipment, have you figured out a method to avoid this? Although I am spraying not near computers there is still white coating everywhere. Same question goes for zirconia cleaning before sintering. Gessobox?

 

[2thm8kr]

Solution 1

Solution 2: Make a paint booth to catch the over spray.

I made one with a sealed motor bilge fan and a washable filter system.

 

[doug]

Use your old spray opakit box to collect the over-spray. We turned ours into a cooling table for pressed creamics. If I had an extra that's what I'd do.

 

[zero_zero]

Hire a cleaning lady...

 

[Car 54]

I just spray or air gun towards the open area of the room, then as zero said, hire a cleaning lady...can we say that anymore,
or is that sexist and politically incorrect to say these days?

 

[tehnik]

So I hire a cleaning lady, who is cleaning computers and 3d printers from the inside weekly? I think I need to build some kind of large box with suction unit.