Brett Hansen CDT
Well-Known Member
Full Member
- Messages
- 1,679
- Reaction score
- 102
A doctor sent in a model where they would like me to make a "surgical guide" for an implant in tooth 10. The tooth will be extracted and then the implant place on the same day. There is no CBCT scan. Using 3Shape, my plan was to scan the model and design a splint incorporating about 7-12 that will go about half way down the teeth. I will print the splint and then manually drill a hole in 10 where I think an ideal screw channel hole would end up. Does that sound right?