Set up a job in exocad

millennium

millennium

Active Member
Full Member
I would like to copymill the wax up with buccal reduction for porcelain on anteriors. How would I set up the job? "Reduced wax up" for all the units and "screw retained manual positioning" for the implants. There is an implant between #6 and #7, how would I go about that? And #9 is ASC Ti base. thumbnail_20191205_175955.jpg
 
OP
millennium

millennium

Active Member
Full Member
@2thm8kr, when I select every unit I get two multi die choices one for implants and the other for the rest of the teeth that don't exist so I cant scan them. If I only select the implants and ignore the rest of the teeth I get two wax up scans. The software separates #4 from #5,7,9,12 I guess because 4 is next to 5. What should I do to have only one multi die scan and only one wax up scan?
 
2thm8kr

2thm8kr

Beanosavedmysociallife
Full Member
Show me screen shot of DB set up.
 
OP
millennium

millennium

Active Member
Full Member
What should I do about the pontics? "Reduced pontic"? But than its not in the copymilling section.
 
2thm8kr

2thm8kr

Beanosavedmysociallife
Full Member
You should have marked as reduced wax up tooth #' 4,5,7,9,12. Leave the rest blank.
For implant option each tooth select screw retained manual positioning.
 
OP
millennium

millennium

Active Member
Full Member
You should have marked as reduced wax up tooth #' 4,5,7,9,12. Leave the rest blank.
For implant option each tooth select screw retained manual positioning.
That's exactly what I did and I get two wax up scans instead of one
 
OP
millennium

millennium

Active Member
Full Member
Wax up #1 is implant #4 only
 
OP
millennium

millennium

Active Member
Full Member
That's it! You solved it! Unf****n believable. Thank you!
 
Private conversations
Help Users
    You haven't joined any rooms.
    Top Bottom