Scanner licenses

C

cskiff

Member
Full Member
I have scanner that doesn’t have a license. Is this necessary. I have the software it’s asking for a license. If scanner needs one how would I get it this is AG system. Any help would be great
 
Affinity

Affinity

Well-Known Member
Full Member
What scanner? I wouldnt be surprised if it needs the dongle to work becuase the software is all bundled to the ceramill mind dongle. How could you get the software to work? You might be able to get it to run on the original manufacturers software, I think it could be an Imetric if its the map 300.. ?
 
B

bigbrush

Active Member
Full Member
If it´s a AG scanner thanit is software by smart optics.
You shouuld ask your dealer to support.
 
C

cskiff

Member
Full Member
What scanner? I wouldnt be surprised if it needs the dongle to work becuase the software is all bundled to the ceramill mind dongle. How could you get the software to work? You might be able to get it to run on the original manufacturers software, I think it could be an Imetric if its the map 300.. ?
I have the 300 scanner now that’s works fine. This I the mapp 400 it asks for calibration when I click ok a new message shows asking for calibration key.
 
C

cskiff

Member
Full Member
What scanner? I wouldnt be surprised if it needs the dongle to work becuase the software is all bundled to the ceramill mind dongle. How could you get the software to work? You might be able to get it to run on the original manufacturers software, I think it could be an Imetric if its the map 300.. ?
I have the map 300 works fine the problem is the new map 400 + key
 
Guest Room
Help Users
  • No one is chatting at the moment.
  • Chat Bot:
    Room has been pruned!
    Chat Bot: Room has been pruned!
    Top Bottom