Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland dwx 52dci lines on zirconia crown surface???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Darren S" data-source="post: 338469" data-attributes="member: 3089"><p>Here is my two cents. We recently have had major issue with parting lines on out 52DCI. Fortunately we are under warranty still. Had the traverse and the spindle changed out and all firmware and software updated. We did everything from Spindle Tightening & Auto Correction prior to coming up with this solution. It has fixed everything and the mill has not had an error or parting line since. Now our 52D is showing the same issue with parting lines and the spindles are on back order. If you still have the option to buy extended warranty, do so. Both spindles have less than 2000 hours on them. Just took delivery on the mills last February of 2020. I wasn't here for the decision on these machines.</p></blockquote><p></p>
[QUOTE="Darren S, post: 338469, member: 3089"] Here is my two cents. We recently have had major issue with parting lines on out 52DCI. Fortunately we are under warranty still. Had the traverse and the spindle changed out and all firmware and software updated. We did everything from Spindle Tightening & Auto Correction prior to coming up with this solution. It has fixed everything and the mill has not had an error or parting line since. Now our 52D is showing the same issue with parting lines and the spindles are on back order. If you still have the option to buy extended warranty, do so. Both spindles have less than 2000 hours on them. Just took delivery on the mills last February of 2020. I wasn't here for the decision on these machines. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland dwx 52dci lines on zirconia crown surface???
Top
Bottom