Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland DWX-51D and DWX-52DCi milling issues... or is it millbox?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Endzo" data-source="post: 350569" data-attributes="member: 18855"><p>Had a bur snap because it stuck during a wax (veneer) mill. Immediatly started getting parting lines. Callibrated three times, spindle run-in, bur change test, re-tighten collet, re-boot and unplug computer, no change. Ran a mill on the 5 axis modes, and it completely solved the problem. Went back to 3+2 mode, no more lines. Been line-free for the last 20 units. Decided just to stick with 5 axis even though it takes a little longer.</p></blockquote><p></p>
[QUOTE="Endzo, post: 350569, member: 18855"] Had a bur snap because it stuck during a wax (veneer) mill. Immediatly started getting parting lines. Callibrated three times, spindle run-in, bur change test, re-tighten collet, re-boot and unplug computer, no change. Ran a mill on the 5 axis modes, and it completely solved the problem. Went back to 3+2 mode, no more lines. Been line-free for the last 20 units. Decided just to stick with 5 axis even though it takes a little longer. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland DWX-51D and DWX-52DCi milling issues... or is it millbox?
Top
Bottom