Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland DWX-51D and DWX-52DCi milling issues... or is it millbox?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="npdynamite" data-source="post: 337791" data-attributes="member: 11802"><p>What cam software are you running? I was talking to our tech who runs the mills and he is not aware of any way to change the bur size specifics in millbox. We did measure our 2mm bur and it measured at 1.91, this seems like it would be causing bigger issues if that was part of it. I would like to think that the creator of the tool paths is aware that the bur is actually slightly smaller but they just call them by easier rounder numbers</p></blockquote><p></p>
[QUOTE="npdynamite, post: 337791, member: 11802"] What cam software are you running? I was talking to our tech who runs the mills and he is not aware of any way to change the bur size specifics in millbox. We did measure our 2mm bur and it measured at 1.91, this seems like it would be causing bigger issues if that was part of it. I would like to think that the creator of the tool paths is aware that the bur is actually slightly smaller but they just call them by easier rounder numbers [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland DWX-51D and DWX-52DCi milling issues... or is it millbox?
Top
Bottom