rkm rdt
Well-Known Member
Full Member
- Messages
- 21,409
- Reaction score
- 3,288
You have nice hands though...
haha thank you! these are courtesy of @rc75Nice looking Inc translucency and look..not grey, not white. What zirconia did you use, oh, pray tell
you buying me dinner next?You have nice hands though...
You have nice hands though...
When you get a nice prep and retracted tissue, then the crowns will usually drop into place without much trimming. Of course that's in a perfect world.thanks, thats a good idea. will give that a go on the next case! always looking to improve everything including presentation.
honestly wasnt super worried...if you see in the one pic the posteriors are all melting away, as the anteriors were too. these restorations were for a prior (or current) meth user. ew.
or JerkinsHe uses Palmolive
*Jergensor Jerkins
man i want to pick your brain about that more. i have a handful more clients going digital and i want to be fully on board with them on their journey (more than i am now)When you get a nice prep and retracted tissue, then the crowns will usually drop into place without much trimming. Of course that's in a perfect world.
This is why I love working from an IOS. I know some techs go modeless but I see it as painting a picture without placing it in a beautiful frame.
man i want to pick your brain about that more. i have a handful more clients going digital and i want to be fully on board with them on their journey (more than i am now)
I trained all my drs with my own intra oral scanner hoping they would buy their own someday and they did.man i want to pick your brain about that more. i have a handful more clients going digital and i want to be fully on board with them on their journey (more than i am now)
haha thank you! these are courtesy of @rc75
ETMLB1 milled, than stained and microlayered with Jensen Miyo. i honestly had a blast with the miyo on this one as i do on many i microlayer.
Where do you outsource your milling?The Zr is Jensen XT and the porcelain is e.max Ceram layered with enamels only. I'm a one man lab, I do my own designing with Exocad but I outsource my milling.