rivfordental
Active Member
Full Member
- Messages
- 122
- Reaction score
- 0
Hello,
Thanks beforehand to the community.
TLDR, we are having problems milling Zirconia inlays/onlays, everytime the machine chips the job. We have changed the burs, calibrated the machine, we are using 3shape for the design. What are the recommended parameters in 3Shape for inlay/onlay/veneers. What is the recommended angle of the margin?
Thanks beforehand to the community.
TLDR, we are having problems milling Zirconia inlays/onlays, everytime the machine chips the job. We have changed the burs, calibrated the machine, we are using 3shape for the design. What are the recommended parameters in 3Shape for inlay/onlay/veneers. What is the recommended angle of the margin?