Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Problem with Zenotec CAM V3
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Sevan P" data-source="post: 352407" data-attributes="member: 7766"><p>I have had this happen on v3.4 and 32.5 The id in the info stays the same, I delete the tooth an dre import it, But restarting the pc helps and making sure your not running the CNC on the same pc is the biggest help. I separated the CNC from the Cam pc and boom a world of improvement. Cam runs faster and the CNC run normally as always. I notcied that when the CNC and Cam were on the same pc, CAm would bog while cnc was running on the HP elite pc. Hopes this helps. Also closing the CAM and re opening helps as well.</p></blockquote><p></p>
[QUOTE="Sevan P, post: 352407, member: 7766"] I have had this happen on v3.4 and 32.5 The id in the info stays the same, I delete the tooth an dre import it, But restarting the pc helps and making sure your not running the CNC on the same pc is the biggest help. I separated the CNC from the Cam pc and boom a world of improvement. Cam runs faster and the CNC run normally as always. I notcied that when the CNC and Cam were on the same pc, CAm would bog while cnc was running on the HP elite pc. Hopes this helps. Also closing the CAM and re opening helps as well. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Problem with Zenotec CAM V3
Top
Bottom