D
digimiller
Member
Full Member
- Messages
- 48
- Reaction score
- 0
Hello all,
So I am using a Rapidshape printer D40 (fairly new... 20-30 prints),I have an issue with removing models with dies from the build tray. It is stuck on so tight and difficult to remove. I can not go below 150% burn in factor because of the new resin material I am trying. I do print the models and dies separately but the models are hard to take off. As well i do get a flash shiny layer on the base of the model which is separated from build tray. I design with exocad. I am fairly beginner to the digital world from old style of doing everything manually.
So I am using a Rapidshape printer D40 (fairly new... 20-30 prints),I have an issue with removing models with dies from the build tray. It is stuck on so tight and difficult to remove. I can not go below 150% burn in factor because of the new resin material I am trying. I do print the models and dies separately but the models are hard to take off. As well i do get a flash shiny layer on the base of the model which is separated from build tray. I design with exocad. I am fairly beginner to the digital world from old style of doing everything manually.