FastShipper
Member
Full Member
- Messages
- 31
- Reaction score
- 0
Hey all, we've been using an entry level printer for a while now as we've only been doing cases for one clinic and it's been working without issue. We're now printing cases for another clinic and I'm getting all sorts of issues. The new clinic is using the Dentsply Connect Case Center and while it works fine for downloading the .stl files, they aren't printing worth a dang. I can't figure out if it's the files and scans or the printer and how it's setup, (or lack there of.)
We're using a Phrozen Shuffle with ApplyLabWorks MSLA dental resin and Chitubox. I'm orienting the models on the build plate perpendicular with teeth away from the plate and adding as many supports as possible; 50% of the time the supports aren't building and it's causing the model to print awkward or not print at all, cutting off margins and having prep teeth with an angle that isn't supposed to be there. I'm also getting the build sticking to the inside of the resin tub instead of the build plate. The only time it won't is if I completely clean out the resin tub after every single print which I shouldn't have to be doing.
I'm no wizard at all with 3D printing but if anyone has any questions that could help direct me towards an answer, fire away. I'm sure I'll have more questions. I can also post photos as needed.
We're using a Phrozen Shuffle with ApplyLabWorks MSLA dental resin and Chitubox. I'm orienting the models on the build plate perpendicular with teeth away from the plate and adding as many supports as possible; 50% of the time the supports aren't building and it's causing the model to print awkward or not print at all, cutting off margins and having prep teeth with an angle that isn't supposed to be there. I'm also getting the build sticking to the inside of the resin tub instead of the build plate. The only time it won't is if I completely clean out the resin tub after every single print which I shouldn't have to be doing.
I'm no wizard at all with 3D printing but if anyone has any questions that could help direct me towards an answer, fire away. I'm sure I'll have more questions. I can also post photos as needed.