New Group Created - Exocad users

CoolHandLuke

CoolHandLuke

Idiot
Full Member
Messages
10,078
Solutions
1
Reaction score
1,411
CoolHandLuke has created a new group called Exocad users.

All exocad discussion
 
2thm8kr

2thm8kr

Beanosavedmysociallife
Full Member
Messages
11,304
Reaction score
2,510
Nice, derailed on the first reply. 👽
 
CoolHandLuke

CoolHandLuke

Idiot
Full Member
Messages
10,078
Solutions
1
Reaction score
1,411
still waiting rkm, send me those scans
 
2thm8kr

2thm8kr

Beanosavedmysociallife
Full Member
Messages
11,304
Reaction score
2,510
3Sheep must not have come with instructions or CAD points to send those to you?
 
TheLabGuy

TheLabGuy

Just a Member
Full Member
Messages
6,223
Reaction score
817
That's what happens when 3shape hates exocad so much!!! 3shapes corrupts any other files that aren't 3shape!!! If I had an x-wife, I'd bet her name would be 3Shape. If I get bit by a dog tomorrow, I'd bet the dog's name is 3Shape. Heck, I stopped using cuss words years ago...who needs words like fk, when 3shape sounds so much better...lol. I did pick up a new trios client today though...go figure.
 
2thm8kr

2thm8kr

Beanosavedmysociallife
Full Member
Messages
11,304
Reaction score
2,510
With all those dead mink you know the licensing is bound to go up in the upcoming quarter.
 
Tayebdental

Tayebdental

Tayeb S. CDT
Donator
Full Member
Messages
3,238
Reaction score
470
Ok. I have a question. How to block holes and discrepancies on dies during design in Exocad instead of using scanning wax before hand?
 
Last edited:
CoolHandLuke

CoolHandLuke

Idiot
Full Member
Messages
10,078
Solutions
1
Reaction score
1,411
Ok. I have a question. How to block holes and discrepancies on dies during design in Exocad instead of using scanning wax before hand?
right click your scan, select Edit Meshes, click Close Holes.
 
ps2thtec

ps2thtec

Well-Known Member
Donator
Full Member
Messages
2,486
Reaction score
620
Ok. I have a question. How to block holes and discrepancies on dies during design in Exocad instead of using scanning wax before hand?

are you asking How to blockout, (fill in),say a bubble hole in the die? What I found is that I have to do that before the wizzard opens.
-Expert mode,... right click die for dropdown screen
-free form scan data.
hide the crown parts and Antagonist, and the die stays yellow to be able to free form.
If I’m into wizzard, I’m unable to keep jaw scan yellow to free form it.
This was spoken like a non-techie!🤔 Please excuse me.
 
Last edited:
EJADA

EJADA

Well-Known Member
Full Member
Messages
781
Reaction score
116
Sooo been off the radar for quite a while. But this group will get me back on more. Just been way too busy. Looking forward to some good stuff here.
EJADA
 
Top Bottom