NEED HELP!!!

DreN4do

DreN4do

Active Member
Full Member
Messages
134
Reaction score
0
hi guys.

long time no post! anyhow, i got a question....

i was scanning a case with a medentika scan body as usual... (not my first time),when i finished the scan,
the final product shows the analog away from the scan... as you can see the direction of the analog is dead
on, but it's not touching the model! any ideas? Screenshot (1).png Screenshot (2).png Screenshot (3).png Screenshot (2).png
 
Affinity

Affinity

Well-Known Member
Full Member
Messages
5,587
Reaction score
1,062
It looks like the library geometry just isnt showing up, in exocad you have a slider to make that portion go away, it doesnt load until you start working on the implant usually...
 
Sevan P

Sevan P

Well-Known Member
Full Member
Messages
3,244
Reaction score
641
You're fine, the scan body your aligning to the scan most likely has the interface cut off, for other reasons, It is right. As long as the scan looks like the model you are fine.
 
DreN4do

DreN4do

Active Member
Full Member
Messages
134
Reaction score
0
You're fine, the scan body your aligning to the scan most likely has the interface cut off, for other reasons, It is right. As long as the scan looks like the model you are fine.
as always, you are right..... :) thank you.
 

Similar threads

Top Bottom