K
Kelvin Tantono
Member
Full Member
- Messages
- 41
- Reaction score
- 7
yeah sure. you guys are the one who keep me going. Dtrial and error! all good keep us posted
yeah sure. you guys are the one who keep me going. Dtrial and error! all good keep us posted
one year later, what were your results Kelvin?So, hello everyone. I am a very new player in the world of CAD / CAM Zirconia. A supplier sell me a system consisting of Bruxzir HT block, Burxzir dipping liquid, and Tanaka ZirColor
I have been playing with them for around one month, almost 70 units of crowns of trial and error, but still get no good result.
If you dont mind, i will tell you how I do my zirconia, and please correct me and tell me where I do wrong. I am very open to all you guys are telling me. And i promise to tell you the result from all your seuggestion.
So, I was instructed (by the supplier) to dip the milled green-state zirconia into the Bruxzir liquid for 5 minutes (although the instructions said it should be 15 minutes, but i dont dare to try coz 5 minutes dipping already give me a very dark color),and then dry it with tissue / napkins, then i put it into a dish dryer (only heat, no vapor),for one hour. and then take it out, stain it with Tanaka ZirColor. and go to sintering directly.
The result, sometimes very gray, sometimes very light,and very hard to match with the shade guide.
I hope someone here could give me some guide. Thank you
2020. Kelvin is now one of the best technician in Indonesia. He is also currently one of Shofu Speaker in Southeast Asia areaone year later, what were your results Kelvin?
Yess, he is more active in Instagram, you can check his IG : Zirmon Dental Atelier. He post all of his works on Instagramare you ... serious? i can't tell.