Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Milling tool replacement timing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MrMolar" data-source="post: 338566" data-attributes="member: 25202"><p>I replace when I notice chipped margins. 1.0mm is generally the one cutting margins and usually the one to wear fastest. 2.0mm does the bulk material removal/general shaping. 1.0mm does the fine contouring of the buccal lingual and IP areas. 0.6mm fine tunes any anatomy you have in the occlusal surface and also engraves if you do that. </p><p></p><p>I replace the tools as v-panel shows. first reason being if I wait until the margins chip, then I'm wasting material. which sometimes can be as costly as just replacing the bur when vpanel tells me to. I only replace the ones that are wore out. </p><p></p><p>FWIW, I've replaced 2 of the 1.0mm to 1 of the 2.0mm.</p></blockquote><p></p>
[QUOTE="MrMolar, post: 338566, member: 25202"] I replace when I notice chipped margins. 1.0mm is generally the one cutting margins and usually the one to wear fastest. 2.0mm does the bulk material removal/general shaping. 1.0mm does the fine contouring of the buccal lingual and IP areas. 0.6mm fine tunes any anatomy you have in the occlusal surface and also engraves if you do that. I replace the tools as v-panel shows. first reason being if I wait until the margins chip, then I'm wasting material. which sometimes can be as costly as just replacing the bur when vpanel tells me to. I only replace the ones that are wore out. FWIW, I've replaced 2 of the 1.0mm to 1 of the 2.0mm. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Milling tool replacement timing
Top
Bottom