Millbox DGShape Version

M

MrNeverFixit

Active Member
Full Member
Messages
169
Reaction score
0
For 3 flutes tools you need to decrease the spindle rpm
Are you talking about the rpm in vpanel? We just ran it the way it was setup by defaulf after install. Also my reseller do no release any update for millbox2021.
 
N

Nazar

Member
Full Member
Messages
43
Reaction score
0
Actually the primotec tools are not bad at all, but they need a little tuning)
 
M

MrNeverFixit

Active Member
Full Member
Messages
169
Reaction score
0
Don't change them, you can create your own disk and make any kind of gradient you want there
I will have to do that. And i cant use their millbox version either.
 
N

Nazar

Member
Full Member
Messages
43
Reaction score
0
Changing rpm in a vpanel is a simplest way, but you need to be near the machine to change it back. You can change that in sum3d in a tool room
 
M

MrNeverFixit

Active Member
Full Member
Messages
169
Reaction score
0
Actually the primotec tools are not bad at all, but they need a little tuning)
Probably will have to pay money to do the tweaking. I will contact cims on monday.
 
N

Nazar

Member
Full Member
Messages
43
Reaction score
0
Do you know where to change the gradient?
 
M

MrNeverFixit

Active Member
Full Member
Messages
169
Reaction score
0
Changing rpm in a vpanel is a simplest way, but you need to be near the machine to change it back. You can change that in sum3d in a tool room
The problem with vpanel sometimes it wont save the changes.
 
N

Nazar

Member
Full Member
Messages
43
Reaction score
0
It doesn't, it a safety precautions, if you forget to change it back
 
M

MrNeverFixit

Active Member
Full Member
Messages
169
Reaction score
0
Do you know where to change the gradient?
Open millbox, press ctrl+d, window will popup for various type of disc and edit on any of the multilayered disc and you will just be there with a color square box
 
M

MrNeverFixit

Active Member
Full Member
Messages
169
Reaction score
0
Our millbox version is not the advance mode so cant open the camwinc.exe i have tried it before.

Since you say 3flute reqd slowing down rpm. May be my reseller are not aware of this. They should know better i hope. As they have a lot of customers and i assume im not the only one having issues
 
N

Nazar

Member
Full Member
Messages
43
Reaction score
0
We used them before, and everything was fine after we changed some parameters
 
N

Nazar

Member
Full Member
Messages
43
Reaction score
0
We used another manufacturer which looked exactly like those ones
 
Top Bottom