tehnik
Active Member
Full Member
- Messages
- 520
- Reaction score
- 12
Hi,
I am having problems with manually positioned screw retained restorations. In the millbox everything seems ok, but when running simulation, the inner side is incomplete. I have also broke some burs due to this problem. Sometimes recalculating helps with deleting some lines and detecting them again when screw channel is incomplete, but with inner side.... I have to do the job again. I don't have to rescan, just start the design from the beginning. This however is wasting time. Is there any other solution for this problem?
I am having problems with manually positioned screw retained restorations. In the millbox everything seems ok, but when running simulation, the inner side is incomplete. I have also broke some burs due to this problem. Sometimes recalculating helps with deleting some lines and detecting them again when screw channel is incomplete, but with inner side.... I have to do the job again. I don't have to rescan, just start the design from the beginning. This however is wasting time. Is there any other solution for this problem?