Jeneric/Pentron Autopress Plus troubleshooting

[kiva]

Hi,
I have Jeneric/Pentron Autopress Plus furnace, S/N APD1274 and problem with error code 6.
Anyone has a troubleshooting manual for the furnace?
Thanks
kiva

 

[ps2thtec]

Mine is the JP1200 reg furnace but here’s what the book says for error 6.

 

[kiva]

ps2thtec,
Thank you very much.
I replaced triac semiconductor before. It did not help.
It works sometimes by turning off and on.
Now I like to troubleshoot further on that problem.
I like to try to reset factory default or update the firmware.
Do you know the key to reset or where I can update firmware?
Any suggestion?
kiva

 

[ps2thtec]

ps2thtec,
Thank you very much.
I replaced triac semiconductor before. It did not help.
It works sometimes by turning off and on.
Now I like to troubleshoot further on that problem.
I like to try to reset factory default or update the firmware.
Do you know the key to reset or where I can update firmware?
Any suggestion?
kiva

The company is no longer, having been acquired and killed by HS. Someone mentioned that George, who ran Chrysalis
is still around somewhere? Maybe someone else knows? Have you tried Garland, a sponsor on this site.

Read this thread....
https://dentallabnetwork.com/forums...o-press-plus-trouble-shoot.28817/#post-292809

 

[ps2thtec]

Read this thread also.....
https://dentallabnetwork.com/forums...o-press-plus-trouble-shoot.28817/#post-292809

 

[kiva]

Read this thread also.....
https://dentallabnetwork.com/forums...o-press-plus-trouble-shoot.28817/#post-292809

I got the pdf downloaded and thanks.