Ivoclar esthetics Prime vs MT Multi

user name

user name

Well-Known Member
Full Member
Messages
6,960
Reaction score
1,633
Ive used some ZirCAD MT Multi with decent results, ut am thinking about trying some Prime.
Any experience? Ive got a big multi implant case, (singles and 3 unit),in 1M1. The Prime is stronger and has more shade options, so...?
 
user name

user name

Well-Known Member
Full Member
Messages
6,960
Reaction score
1,633
We have both. We primarily us the Prime
Have you used any of the bleach shades? Would the BL-4 be a good choice for a 1M1?
Same sinter cycle?
 
Doris A

Doris A

Well-Known Member
Full Member
Messages
3,813
Solutions
1
Reaction score
1,033
Have you used any of the bleach shades? Would the BL-4 be a good choice for a 1M1?
Same sinter cycle?
I don't know about C&B but on the shade tabs and denture teeth 1M1 matches a B1.
 
user name

user name

Well-Known Member
Full Member
Messages
6,960
Reaction score
1,633
I don't know about C&B but on the shade tabs and denture teeth 1M1 matches a B1.
Agreed, ut not all Zr looks equal. Ivee had some that runs a bit low in value, others that are way too high.
 
Contraluz

Contraluz

Well-Known Member
Full Member
Messages
1,452
Reaction score
275
Ive used some ZirCAD MT Multi with decent results, ut am thinking about trying some Prime.
Any experience? Ive got a big multi implant case, (singles and 3 unit),in 1M1. The Prime is stronger and has more shade options, so...?
I use both. Depending on the case, I choose Prime or Multi. As soon as there are pontics and/or cantilever, I go Prime. Ivoclar has a couple of preprogramed programs. I mostly stick to them. On most cases, I use the long, overnight program. When using the shorter programs, it seems the zirconia is slightly higher in value. maybe something you want to take into consideration.
 
G

grantoz

Well-Known Member
Full Member
Messages
1,749
Reaction score
366
user name check the fine print about ivoclar prime the incisal part is only 650 mpa so be very careful when you nest this large case if you connectors are in the 650 zone you have a week bridge.
 
R

Rajiv

New Member
Messages
4
Reaction score
0
Is the sintering and glazing program the same for prime or mt multi in the furnace. We have the CS4. thanks
 
Patrick Coon

Patrick Coon

Well-Known Member
Full Member
Messages
1,163
Reaction score
565
Is the sintering and glazing program the same for prime or mt multi in the furnace. We have the CS4. thanks

No, they are not the same. Because of it's unique properties, Prime CAN NOT be sintered in the CS4 furnace.
 

Similar threads

Contraluz
Replies
25
Views
2K
Holy
Jason D
Replies
0
Views
490
Jason D
Jason D
user name
Replies
41
Views
2K
CoolHandLuke
CoolHandLuke
Brett Hansen CDT
Replies
28
Views
3K
Brett Hansen CDT
Brett Hansen CDT
Top Bottom