In Lab Zirconia Manufacturing Cost Calculator

doug

doug

Well-Known Member
Full Member
That's pretty interesting. Thanks for sharing.
 
Solaris

Solaris

Member
Full Member
Thank you for sharing very interesting, could you maybe add monthly software fee and spindle usage per unit to your calculator.
Average life of a spindle is 3000 hours and 10 minutes milling time for a crown. Estimate price for a spindle 2500$
I did a similar calculation plus some other side cost and the result was 30$ which is half cost of sending the case out to a milling centre.



Sent from my iPad using Tapatalk
 
OP
AlienMilling

AlienMilling

Active Member
Full Member
Thank you for sharing very interesting, could you maybe add monthly software fee and spindle usage per unit to your calculator.
Average life of a spindle is 3000 hours and 10 minutes milling time for a crown. Estimate price for a spindle 2500$
I did a similar calculation plus some other side cost and the result was 30$ which is half cost of sending the case out to a milling centre.
Half the cost of a milling center? We're milling crowns over here for $22. Which milling center is charging $60?


Sent from my iPad using Tapatalk
 
Solaris

Solaris

Member
Full Member
It is a milling centre Canada, everything here is more expensive compare to US.


Sent from my iPad using Tapatalk
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
I don't pay $60. In fact I just received a flyer from a centre in Quebec for $20.
 
S

Solaris01

Member
I don't pay $60. In fact I just received a flyer from a centre in Quebec for $20.
Good for you and I also heard that the price properties and the rent cheap to compare to other big cities in Canada.
Do you want to compare Quebec to Vancouver ?



Sent from my iPhone using Tapatalk
 
Guest Room
Help Users
  • No one is chatting at the moment.
    There are no messages in the chat. Be the first one to say Hi!
    Top Bottom