D
drstranger
Member
Full Member
- Messages
- 33
- Reaction score
- 6
Hi,
I am just setting up my Imes Icore 250i machine and since i moved it from one place to the other i have weirdly deep lines in the occlusion. I noticed that the crown are way too thick as well.
A coping I milled was supposed to be 0.3-0.4mm thick, but the milled coping is in some parts 1.3mm thick(occlusally) and 0.5-0.6 from the sides.
What could be wrong? I am using SUM3D for the calculation.
I am just setting up my Imes Icore 250i machine and since i moved it from one place to the other i have weirdly deep lines in the occlusion. I noticed that the crown are way too thick as well.
A coping I milled was supposed to be 0.3-0.4mm thick, but the milled coping is in some parts 1.3mm thick(occlusally) and 0.5-0.6 from the sides.
What could be wrong? I am using SUM3D for the calculation.