How to mill more than one Emax CAD in a Motion 2

Tunajoe

Tunajoe

Member
Full Member
Messages
98
Reaction score
0
So I have a couple of veneers to mill and I have the blocks.
In the past, I'll just mill one at a time since I'm not sure what the nesting process for more than one
The tool holder holds 3 blocks at a time so I'm sure its possible.
Anyone want to chime in?
Thanks in advance

tool block.png veneer.png
 
ArmDent

ArmDent

Member
Full Member
Messages
14
Reaction score
1
I see you have one adapter for milling emax on AG Mill you should have two more.
When you have 2 or 3 restorations to mill you would need to nest your design one at the time and each time you choose right, center and left holder/ adapter. (program defaults on center every time) choose correct holder from drop down window on left corner of nesting software.
When nesting is done. One at the time, in your milling software you need to choose to mill job 1, 2 and 3 to mill
You are done )
I hope it helped.
 
Amann Girrbach

Amann Girrbach

Member
Full Member
Messages
51
Reaction score
8
Hello Tunajoe, check in with our helpdesk, they will help you with the process to mill more than 1 at a time.
Thanks!
 
Tunajoe

Tunajoe

Member
Full Member
Messages
98
Reaction score
0
Check in with your help desk?
is this like the Ritz Carlton?
where do I find the help desk?
 
JMN

JMN

Christian Member
Full Member
Messages
12,205
Reaction score
1,884
Check in with your help desk?
is this like the Ritz Carlton?
where do I find the help desk?
It's more like 'Help! Desk!' after it falls on you.

(not picking on AG at all, it was just too funny of a visual to leave alone)
 
M

MolarMania

Member
Full Member
Messages
27
Reaction score
14
I hear crickets from AG. No response to get info on contacting HELP DESK. Posted last November..
 
Top Bottom