How to mill more than one Emax CAD in a Motion 2

Tunajoe

Tunajoe

Member
Full Member
Messages
75
Points
16
So I have a couple of veneers to mill and I have the blocks.
In the past, I'll just mill one at a time since I'm not sure what the nesting process for more than one
The tool holder holds 3 blocks at a time so I'm sure its possible.
Anyone want to chime in?
Thanks in advance

tool block.png veneer.png
 
ArmDenT

ArmDenT

Member
Full Member
Messages
14
Points
13
I see you have one adapter for milling emax on AG Mill you should have two more.
When you have 2 or 3 restorations to mill you would need to nest your design one at the time and each time you choose right, center and left holder/ adapter. (program defaults on center every time) choose correct holder from drop down window on left corner of nesting software.
When nesting is done. One at the time, in your milling software you need to choose to mill job 1, 2 and 3 to mill
You are done )
I hope it helped.
 
Amann Girrbach

Amann Girrbach

Member
Sponsors
Full Member
Messages
51
Points
18
Hello Tunajoe, check in with our helpdesk, they will help you with the process to mill more than 1 at a time.
Thanks!
 
Guest Room
Help Users
  • No one is chatting at the moment.
  • Chat Bot:
    Room has been pruned!
    Chat Bot: Room has been pruned!
    Top Bottom