Hole in 3Shape Crown

Sarah Downs

Sarah Downs

Active Member
Full Member
Messages
108
Reaction score
31
So I'm not sure what happened to this crown. I haven't tried redesigning yet because I was wondering if there might be an actual solution. But my crown has a hole in it somehow.

Has anyone seen this before and know how to fix it? Thanks!
 
Last edited:
Smithwick0208

Smithwick0208

Active Member
Full Member
Messages
375
Reaction score
28
Check the margin for missing data where the distortion is pulling towards.
 
Affinity

Affinity

Well-Known Member
Donator
Full Member
Messages
6,918
Reaction score
1,062
Always put the 'show undercuts' selection on when marking the margins, especially for bridges. If you draw over the red, it will change your margin and you wont notice unless you recheck it. I see demos online where design companies dont do this, bad idea.
 

Similar threads

Top Bottom