D
DPS
Member
Full Member
- Messages
- 50
- Reaction score
- 0
So i'm quite a beginner on full arches and i'm not sure what i did wrong . I Would appreciate if you check on my design and correct me.
The rocking seems to be in the midline area .Colleague tried to remove undercuts with grinding post sinter , as he always does that and eveyrything turns out fine . But this one just got worse.
I set different radial spacers on the abutments with undercuts ( 20 microns difference ) . Could it be the problem ?
The rocking seems to be in the midline area .Colleague tried to remove undercuts with grinding post sinter , as he always does that and eveyrything turns out fine . But this one just got worse.
I set different radial spacers on the abutments with undercuts ( 20 microns difference ) . Could it be the problem ?