K
klsdjhfahf
Member
- Messages
- 2
- Reaction score
- 0
Hello,
I have a problem that I am having a hard time trying to figure out.
I have a single wax up scan that I am trying to cut into 3 separate bridges.
Is this even possible?
I have tried many methods to no avail. I have tried to design the 3 bridges separately in different projects and then import them all at once, but the calculation caused many errors.
I have tried to use the waxup scan as a preop and adapt crown to it, but the result is very messy.
I am contemplating milling the three separate bridges with wax and scanning them together but that seems too time consuming.
Any tips are appreciated. Thank you
I have a problem that I am having a hard time trying to figure out.
I have a single wax up scan that I am trying to cut into 3 separate bridges.
Is this even possible?
I have tried many methods to no avail. I have tried to design the 3 bridges separately in different projects and then import them all at once, but the calculation caused many errors.
I have tried to use the waxup scan as a preop and adapt crown to it, but the result is very messy.
I am contemplating milling the three separate bridges with wax and scanning them together but that seems too time consuming.
Any tips are appreciated. Thank you