DWX-50 Spindle Replacement

[JeffT]

Thanks for that info FASTFNGR, great to know. I have just replaced my spindle recently, so hopefully can buy it seperate.
$700 for collet.......bummer
cheers

 

[chaouigram]

Hello! I just ordered a new spindle to have it on stock in the lab. On the box it is written Spindle Unit ZS-4D, but is it compatible with DWX-50 or there is another type of spindle unit only for DWX-50? The leaflet inside described how to change it on DWX 51, 52 ecc., but not on DWX-50. Thanks!

the same works for 50 51 52D . can i ask from where did u buy it and how much . thanks

 

[The Veneer Guy]

Hi all,
With regards to collect replacement/cleaning and maintenance.
How do you know how much it should be tightened after removing collet completely for cleaning or, just tightening it during general maintenance. I always worry I will over tighten. There is no increase in resistance as you tighten it, and it can easily be too loose still.
It's a bit hit and miss. Is there any tips for this?
Thanks

On the 51D, When using the collet loosening and tightening key, when you tighten, it start turning the spindle when it’s tight enough. It doesn’t allow you to over tighten.