Designing a hole in Exocad

[dmonwaxa]

I dont remember having the checkbox for touch anything, but was able to create a hole using attachment remove after merging. I hadcthis isaue again recently when doing screw retained zr over abutment. I resorted to doing design screw channel. Major PITA.

 

[harmonylab]

strange. I finally got it to work.. and it's working on some and not on others. 6 unit temporary bridge, there is no option for ATT, while single crown does. wth?

edit: got it working. must be optimized after merging as well.

 

[Farrah Fawcett]

You wait until after end of design, then gonto expert?

You edit the defaultparameters or the parameters?

 

[harmonylab]

You wait until after end of design, then gonto expert?

You edit the defaultparameters or the parameters?

for bridges, after merging, there's an additional option for optimizing. after that you can add the holes.